Big stahl racing header for sale

[Layne]

I picked this up hoping I could get it to fit onto an E21, but it's not even close. Thought I'd try selling it before I get tempted to start cutting on my car :-) I'm not sure if it's made to go through the floor of an 02 or fit under it, it does appear to dip lower than the one Metric Mechanic sells for going through the floor. I don't have an 02 to try to fit it on, but I can provide any measurements you need. The primary tubes are 1.75", probably not suitable for any street engine. They are equal length at about 32". Output diameter is 3". The #4 tube sticks straight out from the head about 9" (this is my problem, e21 only has 7" to the fender). It is ceramic coated, but some sections of it have peeled off. $250 shipped, or will consider trading for a header that I can use, or other performance M10 stuff.

http://inlinethumb22.webshots.com/40597/2757279690101597211S600x600Q85.jpg (http://good-times.webshots.com/photo/2757279690101597211eLCkLX)
http://inlinethumb06.webshots.com/44101/2427012190101597211S600x600Q85.jpg (http://good-times.webshots.com/photo/2427012190101597211fXsmeq)
http://inlinethumb22.webshots.com/40597/2757279690101597211S600x600Q85.jpg (http://good-times.webshots.com/photo/2757279690101597211eLCkLX)

[leejohn]

I have a really nice ceramic coated Ireland engineering shorty header.
I am in the market for a long one piece like the one u have..
let me know

[bmv1184]

Hello,
I have a pair of small stahl headers that were used on a 2002. I am not sure if they are ceramic coated, but they are a solid header. I am looking for a large diameter header to use with my M10 racing engine. If you still have the headers and would be interested in a trade or even selling them please contact me.

bmv1184@yahoo.com

[kpolito99]

Many many years ago I used that header on my 2002 with 45 DCOE Webber side drafts and a Schrick 316 cam shaft. It passed completely under the floor of the passenger foot well and was often scraped on speed bumps and other roadway obstacles. If memory serve correct it was only 2-2.5 inches above the road surface beneath my lowered 2002.

[M5wanaB]

Many many years ago I used that header on my 2002 with 45 DCOE Webber side drafts and a Schrick 316 cam shaft. It passed completely under the floor of the passenger foot well and was often scraped on speed bumps and other roadway obstacles. If memory serve correct it was only 2-2.5 inches above the road surface beneath my lowered 2002.

This is exactally what I have going on. They really did not make a good place to route exhaust under the chassis. I have about 3" of clearance, I try to avoid speedbumps but they are everywhere. I guess its all about the shorty headers.